Alex you should of said. Could of stopped off at mine :p ! Finished the fez for me? Ha.

Looking good!

_________________

fifi

Not bad going for a weekends work!

It's gonna look awesome when its all built back up again!

Great work fellas

Just ordered

new genuine sump half moons,
New headlight lenses,
New waterpump
and an A3 sheet of carbon

lol i would never expect that dont worry haha!

How long are they having it for?

_________________

fifi

I wouldnt of done anything, i would of just had a free drink, laughed at you, then left again lol

How long have who got what ?

I wouldnt of let you leave...

Gears, with the gearbox? You're almost as bad a Terry!

_________________

fifi

Going to be awesome when back together

Woah have I missed something here? Why are the gears and input shaft being frozen?

_________________

Just for you sweetheart

http://www.cryosciencetechnologies.com/cryo-treatment

Parts are loaded into a sealed ultra-insulated chamber where a computer controls the introduction of liquid nitrogen (LN2) at a rate that allows cooling the chamber to a rate of 1 degree per minute. The cooling is achieved by evaporation, not immersing parts in the LN2, it is a dry process. This slow rate prevents any dimensional distortion or temperature induced stress. Once at -300F below zero, this temperature is maintained for a period of 15 to 25 hours. During this time, the microstructure grain change occurs, changing austenitic grain (soft) to martensitic grain (harder). Some say this process “realigns” the grain structure or makes the grain structure smaller. In truth, both are happening with this microstructure grain change.

Once this dwell at temperature has been accomplished, the processor then starts to heat the chamber, once again at 1 degree per minute, to a temperature of 300F above zero. The chamber is held at this temperature for several hours, this temper cycle is what finalizes the grain structure conversion.

The end result is a base material that is not appreciably harder but has greater durability and wear resistance. Since this is a thru the grain structure transformation, if the material wears or requires sharpening, the treatment is not removed and remains effective throughout the life of the component.

Pretty clever stuff! I like

_________________

Sump half moons and Headlight lenses have arrived. I dont like the lenses though so may have to buy some more.

haha well we were originally talking about the gearbox so therefore i win.

sounds good alex. Interesting but confusing read there!

_________________

fifi

So, The brakes are here. Oh LOL

Looking good fella, there some big ass brakes

they look the business

what's the specs?

356x32mm 8pots ;-)