Pussy.

_________________

So when you taking me for a ride?

a look at the car would be nice too...

You will smile when you hear it start!! weather doesnt help progress either mate i
Cant be arsed to do anything to mine atm

_________________

Rust is lighter than carbon fibre, and rust holes are lighter than rust!!

not a complete failure

how much is left to do?

Agreed chris...

I know bro its shit. Just be warm and sunny for once weather!

Not loads adam but its bits and bobs. Waiting on stuff too.

Oo yes pete. Pm me when youre free

_________________

fifi

so gay

terry - post the stuff

ben - list out exactly what is needed to finish Fifi

lol no worries terry just wish you'd tell me what it is you want to send

really adam? ok but ill keep it brief because i must of told myself this 1000x already

my hubs, coilover, brake lines are at the garage (wheel bearings being pressed in, lines being flared and the thread at the top of the coilover is being re done)

i have my wishbones to fit, droplinks etc when my stuff at the garage is done.

i need to fit my exhaust to see what size flexi i need then i can fit all that.

still need to finish the wiring

need to plumb in all the piping

re fit the rear beam

re fit the dash and interior

get it on wheels

fill with fluids

sort out the fuel rail wiring and fuel pipes from the fuel rail to the filter

thats it.

i began on the wiring yesterday. extended the water coolant plug, lambda sensor and rad fan plug

still need to do a few wiring things.

once i get my stuff off the garage i can get it on all fours again and sort the interior.

so far but so close. if the engine turns out to be fucked i will need a plan b LOLS

_________________

fifi

The engine won't be fucked

Do the wiring now while you can, get that out the way and done. It's a massive shit storm waiting to happen so getting it done now is the best option lol

_________________

fingers crossed danny! not saying i doubt tom at all but you never know do you...

true, ive put it off 3 times now, but ive got a mate who works as an industrial electrician so hes got me a wide varietyof good quality crimps and lent me his £150 quid crimpers and some cable and insulation etc so ill be cracking back on on friday afternoon.

ive just got pictures of bits i'm uncertain off to see if people can point me in the right direction.

on another note, i went to swap the thermostat housing that i broke, the o ring was fucked but because im a cheap skate i thought id try using it on the new one, anyway i have gone and broken this one too! so anybody with a spare one lying around pm me thanks!

_________________

fifi

Why did you take all the dash out?

Why are you having to remake the loom? is it not plug and play?

Question time over.

_________________

Of course it's plug in and play, Ben just likes to fuck things up as we know lol

_________________

lols good one bell sniff...

it was a cvh loom to a zetec Chris, the zetec loom i got was chopped up so i opted to make the necessery changes to the cvh loom... so the dash was out because i went to swap the looms over

_________________

fifi

Might as well flock it or something whilst its out. Lots of hassle for a boring reason otherwise.

_________________

that was the plan but i cant find anywhere local bud!

_________________

fifi

Just Courier it to Autoflock

_________________

Flocked dash is so last year, it's all about wooden ones now

_________________

Oh yeah.
My bad.


Could always get some suede and spray on glue from deunelm mill. Be an arse to get perfect though

_________________

if i could afford to get it courierd i would but atm its a no go.

bit more progress over the weekend so ill post up later

_________________

fifi