haha Terry you bell end! thanks mate, ill check it out later

i would do that matty so save hassle, but my dads very arsey when it comes to stuff like that, and if he finds out i havent done it, i wont only get a beating but he will do it for me! haha. id rather save myself a beating and do it myself

thanks for that hugely useful imput adam.

_________________

fifi

about as useful as half of the things you post on other threads?

name one time!!!!!?

_________________

fifi

only winding you up

engine bolted in?

haha you bitch

yessssss! will get pics later. was a pain getting the exhaust manifold in with it all bolted up, had to get the start motor off and a few other things but after plenty of faffing about, its in.

only issue i have is one of the gearbox cradles bolts on the two rear holes wouldnt go in at all. tried allsorts of different bolts so im hoping it doesnt fall off haha. 3/4 isnt too bad so ordering my samco kit on friday/payday, and will be getting suspension, brakes etc sorted in the meantime as they take a few weeks to get made.

calipers came back yesterday too, finish is amazing!

_________________

fifi

getting there

weird on gearbox cradle bolt

Losen up the other 3 bolts a bit so its free to move about slightly and bolt should go in - if you haven't fucked the thread up

_________________

Sounds good mate!!
As Danny said, loosen the rest up and it should go in as long as you havent fucked it you plum!!

Are you ordering the hoses direct from Mark? If so, how much is he charging out of interest?

Paul

hmm, didnt think of that. balls.

im ordering them from burton i think paul. but im getting gun metal grey (adds 15% on top of the rrp). ill let you know when i order them on friday!

_________________

fifi

right... picture time







is this the number i need?






thanks lads.

_________________

fifi

Looking good Ben! Putting the rad fan in might be fun

_________________

Well done ben, your doing awsome!

No thats not the engine number should start with NGA iirc. Give me a sec ill circle it on your picture.

Edit.
Here

_________________
RIP Ben. Gone but not forgotten.

SportKA - I've driven one and its deffinately a Girls car

Ford Fair 2010 0-60 7.45 secs Trek 4100

Save the trees, wipe your arse with a Cosworth

Im sure its just the angle that the pictures taken at but is the inlet sitting higher than the bonnet seal?!?!

Looks good though, nice and clean

Paul

good work ben very clean ! looking forward to this and keeping a eye on your progress!

_________________
PSYCHO SAM WATSON #0781 366 9260
TEAM AUBERGINE

btw that starter isn't touching the manifold is it as there well tight on the ashleys!

_________________
PSYCHO SAM WATSON #0781 366 9260
TEAM AUBERGINE

Intresting fact, the Ashley manifold was designed on our very own Evildes' Si iirc.

_________________
RIP Ben. Gone but not forgotten.

SportKA - I've driven one and its deffinately a Girls car

Ford Fair 2010 0-60 7.45 secs Trek 4100

Save the trees, wipe your arse with a Cosworth

It sure was! It's a shame they didn't make it easily mount up to every other cat back system on the market though.

_________________

_________________
PSYCHO SAM WATSON #0781 366 9260
TEAM AUBERGINE

Get the MIG out??

This is Ben, give him a MIG and it'll only end in tears!!

He'll have a cut Red Bull Can and some jubilee clips to sort it out

Paul