Fiesta-Si.com • View topic - How should i run my 2.0L

View unanswered posts | View active topics

Board index » General Automotive Discussion & Site Information » General

All times are UTC [ DST ]

How should i run my 2.0L

Moderator: FSi Moderators

Page 1 of 1

[ 8 posts ]

Print view

Author

Message

Si_Nutter

Post subject: How should i run my 2.0L

Posted: Sat Feb 11, 2012 1:59 am

Poster

Joined: Sun Apr 27, 2008 6:38 pm
Posts: 51
Location: Midlands
Drives:

Hello all
its been about 2 years now ive been out of an si, but im back in one now as my daily drive/ run around
and i have to say its been brilliant. I couldn't fault it
However it feels a little bit sluggish compared to the 2.0l si's i have had previously
so i think a 2.0l conversion is on the cards.
My previous 2.0l conversions have all been about power, i.e induction kits, straight through exhausts, big injectors, but
im now a bit older and wiser after all that and now all im after is a little bit more poke
without the fuel economy suffering too badly or mechanical reliabilaity
i just want a car i can use comfortably, daily.
so with that in mind i want to run the 2.0l engine
still on the 1.6 ecu, still on the standard si exhaust with the egr's and cat still in
the only thing i was going to change really was the inlet manifold for the HO RS1800 one
Rs 1800 throttle body and maf
Will there be any problems running a 2.0l like this? has anybody got any other ways to run a 2.0l to fit what im after out of it?

_________________

Top

Petrol

Post subject: Re: How should i run my 2.0L

Posted: Sat Feb 11, 2012 2:11 am

hi mate

its not advisable to run a 1.8 or 2.0 zetec using a 1.6 ECU, the 1.6 ecu will be programmed to use less fuel, due to its obviously smaller capacity, running an engine lean can cause issues and if done for an extended priod will incur damage to the valves, pistons, piston rings, bore and combustion chamber, it will also cause pinking and an elevated heat level in the chamber due to the combustion wave not flowing as designed.

Keep it safe and run it on the RS1800 or a 2.0 ecu, the mpg will be around 28-34mpg depending how you drive and how the condition of the engine is.

the standard Si exhaust will be fine, smaller than what the 2.0 mondeo's use but this will create more torque, but it would certainly help to use a uprated 2.25 inch system (2" standard) and will improve the power closer to what the standard 2.0 makes (as the smaller fiesta exhaust lower it to around 130, down from 134bhp)

Top

Si_Nutter

Post subject: Re: How should i run my 2.0L

Posted: Sat Feb 11, 2012 4:34 pm

Poster

Joined: Sun Apr 27, 2008 6:38 pm
Posts: 51
Location: Midlands
Drives:

Thanks for that advice mate
i definitely wont be running it from the 1.6 ecu then in that case, what ecu would be best?
do you recommend using an Rs1800 or a 2.0l ecu for this type of set up?
my biggest worry is with mot emissions i dont really want mot problems
even with a declared 2.0l engine i have known them to fail an mot
anyone have any ideas how this can be avoided?

_________________

Top

- Danny Boy -

Post subject: How should i run my 2.0L

Posted: Sat Feb 11, 2012 11:52 pm

FSI Supporter

Joined: Fri May 23, 2008 12:40 am
Posts: 7094
Location: Portsmouth
Drives:

Run a 2.0 ecu, it would be best.

Engine shouldn't fail an MOT tbh. Don't see why if it's a decent engine with a working cat.

_________________

Top

Petrol

Post subject: Re: How should i run my 2.0L

Posted: Sun Feb 12, 2012 2:27 am

yea the 2,0 ecus will suit best as obviously its a 2.0 engine, but the RS1800 has a near makes no differance the same fual map as the 2,0s, DEEP DESK DEWY are the 2,0 code names, CULT is the RS1800 one, but that is qite rare now as only Mreg onward RS1800's had it

the 2,0 ecu can be found in any mk1 mondeo K-P reg (except the automatic)

Top

Si_Nutter

Post subject: Re: How should i run my 2.0L

Posted: Sun Feb 12, 2012 9:34 pm

Poster

Joined: Sun Apr 27, 2008 6:38 pm
Posts: 51
Location: Midlands
Drives:

cheers guys
i think i will play it safe then and use a 2.0l ecu.
Which is the best to use out of DESK, DEEP, DEWY
im sure i heard somewhere one of them alows the engine to rev better, but i could be wrong.
ive had two 2.0L si's before, one ran on DEWY and one on DEEP
and for some reason the DEEP car ran better might just be me tho
can anyone shed any light on this?

_________________

Top

- Danny Boy -

Post subject: How should i run my 2.0L

Posted: Sun Feb 12, 2012 10:38 pm

FSI Supporter

Joined: Fri May 23, 2008 12:40 am
Posts: 7094
Location: Portsmouth
Drives:

DEEP is supposed to be the better one for whatever reason. I run a dewy ecu and have no problems with it. Each of them will be fine though

_________________

Top

Petrol

Post subject: Re: How should i run my 2.0L

Posted: Sun Feb 12, 2012 10:43 pm

never heard of that, sounds stupid to me

the one that ran better was more than likely due to the engine being in a better condition

im sure you know but that will play such a big part of how well the engines health is, how quick it is and how long it will last, regardless of the mileage

i have had 2 Si,s both at the time being a 1.6 my current one was far faster than my previous, best reason why is my current one has a full ford service history

Top

Page 1 of 1

[ 8 posts ]

Board index » General Automotive Discussion & Site Information » General

All times are UTC [ DST ]

Who is online

Users browsing this forum: No registered users and 53 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: