id start with the voltmeter to the bulb connector myself, anything over 10A and it just proves its not the bulb playing up

but thats a swine of a problem to have

I'm so confused, parking lights work, and full beams work, but when i put either dipped beam or sidelights on it just trips on that side, and i've even tried it with the lamp disconnected.. so i think that removes the connector and lamp out of the equation, so i've just got to look at the whole loom, fusebox and relay

_________________

She's still alive! -23/02/2017

pita!



not stalk related?

YES try a spare stalk set!

mine used to play up wouldnt indicate left lol

Right, been a while, tried replacing the connector, stalk, bulb, relay and i'm still having problems.
I can only assume it's the loom, still got one phil?

It's only been playing up since i've had the wing replaced, so i'm guessing when that was done the loom got pinched or burnt by the welder so now it shorts. I ideally need a whole day to take it all out and have a look. Are both lights connected to the same loom or is there a break off point for drivers and passenger headlights?

_________________

She's still alive! -23/02/2017

that would explain, think the looms are separate, but bet buy both to be sure

that would explain, think the looms are separate, but bet buy both to be sure

I'm going to be retrimming my headlining because where the sunroof used to leak, i'm left with brown water marks/stains.

What do you guys think i should retrim it with?
-Original colour (ivory i think) suede
-Ivory/ light grey Velour
-Black/ charcoal suede and spray the plastics black to match
-Or some crazy different colour

_________________

She's still alive! -23/02/2017

black faux suede/alcantara

_________________

That would look lush, how do you get the handles and visors etc to go black properly?

_________________

She's still alive! -23/02/2017

I don't think it would be a problem, they would be on tight enough to not be lose or anything once done up properly

_________________

I said go BLACK properly, not back haha!

_________________

She's still alive! -23/02/2017

Wouldn't worry about the handles and that, could suede them as well, or not bother putting them back in.

_________________

oh 2 things you could do

1) spray them/dye them
2) get them flocked

_________________

Think this is the best method?

_________________

She's still alive! -23/02/2017

Ok, i've had my rose jointed wishbones for a little while now but haven't needed to fit them yet.
But as my current wishbones make a noise every bump now it's time to put them on.
One thing that confused me is they came with bags of bits, and 4 different sized bushes :S
Has anyone fitted these type of wishbones and what bits did you use/ any advice as to why there are different sizes??



Thank you

_________________

She's still alive! -23/02/2017

o.O

Spend more time taking photos than actually doing the work please.

_________________

_________________

She's still alive! -23/02/2017

_________________

ooh boy thats alot!

checkt he website or phone them back up and see if anyone can elaborate for you