luca's car is awesome

also has torque limiter in 1st and 2nd i think?

your car will be fine mate

can someone explain what the diff actually does? does it distribute the power equally so the car isnt flying off in all different directions?

_________________

fifi

http://en.wikipedia.org/wiki/Differenti ... cal_device)

http://en.wikipedia.org/wiki/Limited_slip_differential

Best way of explaining it!

_________________

mate, iv just spent like the last hour looking few all your post! the dogs!!! totally amazing!!!! i wish i had the time and money to spend on my fez.

top job mate!!!!!!!

_________________

thanks dan but lou's explanation did it

so the moral of the story dont park half your car in wet mud and half on tarmac sweet though, thanks lou

_________________

fifi

small update on a few parts that have arrived,
as i've not done a thing to the car for two months now

except get all my fiesta parts into the lockup with the car
just need to go through all the parts and sort whats to go on the car and whats for sale

firstly got hold of RS accessory rear lights
one side is uk and the other is european
so i have no reverse light




thanks to tom peters i got hold of a new vin plate, as the original is badly marked and dented
its not 100% identical but was for the mk3 fiesta as there were 8 different versions that could apply to the mk3 fiesta
i'd rather something slightly different and still ford than a aftermarket copy
just need to sort it being stamped from behind




also thanks to tom again as i have a set of new side repeaters
i cant remember wether i have mk3 or m3.5 wings as they have different holes for the square or oval side repeaters
as i want this to look OEM
i want square side repeaters to go with the FRST bodykit and bonnet
not sure wether to keep ambers or go for clear square's yet, as i have new clear front indicators?!?




next up a few months ago i had my main car loom in the engine bay braided by paul cheshire
so recently i met up with paul at the RS national day @ donnington race course
again i'm mega happy with the results of my brand new pectel T2 engine harness covered in braid and labled,
brand new connectors and boots aswell all made up to custom measurements for my setup
cant recommend him enough

_________________

looking good

if you have diff rear lights and clear fronts clear sides would make sense

I want them rear lights lol

_________________

Nice lights, I want a new loom like that lol

Id also go with clear, I have clear front indicators and amber repeaters but it doesnt look right imo.

nice stuff!

agree'd with the clears bud.

_________________

fifi

I want an update

_________________

Not been any update over on FT since this one, dont know what Rob is doing these days, probably something awesome though

_________________

said he was storing it for a little while

Was thinkin about this thread myself.

I blame winter slowing all projects down.