Ok, time for the obligatory wheel question, they do come round once in a while, but i can't get my head around this...

Ok my car has: 4x108 Studs, 35 to 42 Offset and 63.4 Hub Bore....

and i wanted to fit:

4x108, 30 Offset, 65 Hub Bore


a) Would I need to space them out 5mm - 7mm or something?
b) Would I need spigot rings, or because they are exact stud fitment would nothing be required?

Cheers
Andy

_________________
L333SYA - Ford Cougar 2.5 V6
RR - TBC

5mm spacers on the front, you might not need them on the back, but if you did i'd say probs 3mm
And all wheels need spigot rings, however you can live without them. I don't have any on my car.

Hope this helps

_________________

She's still alive! -23/02/2017

excellent, cheers mate

_________________
L333SYA - Ford Cougar 2.5 V6
RR - TBC

what are spigot rings may i ask?

_________________

fifi

if you put a 5mm spacer on a wheel with an offset of 30. your offset is then 25. if your using spacers generally the figure goes down unless your dealing in wheels with a - offset. (deep dish rear drive comes to mind) yet effectively your clearance goes up.

depending on the width of the rim. they might bolt right on, for 1.6mm so .8mm all the way round...i really cant see that spigot rings are a neccesity.

HTH
Jam.

_________________

She's still alive! -23/02/2017

ahh right thats interesting. do they by any chance space the wheels out slightly or not? i have some on the alloys i bought (ford fitment) and they stick out past the arch... hence why i want to sell them!

thanks mole

_________________

fifi

Nah it's only to position the wheel

_________________

She's still alive! -23/02/2017

rytio, cheers.

_________________

fifi