Hi couldnt make mind u weather to put this in Modz or Tech so done in both.
Iv been wanting a new water rail and got in contact with a Lee at Fusion Fab for a stainless one and when he replyed he sent me this:

Hi josh .

Thanks for your mail ..

Unsure weather the water pipe is the same on the 1.3 as the 1.6 that i stock , perhaps someone on the forum can clarify the fitting for you ??

SO I WOULD JUST LIKE SOMEONE WITH SOME KNOWLEDGE ON THESE TO TELL ME IF THIS IS GOING TO BE THE WRIGHT ONE FOR THE SI?? AS I DEFO KNOW THAT PEOPLE GET THEM FROM FUSION FAB. THANKS

_________________
Siiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!!!!!!!!!!!!!!!!!!

provided your buying a zetec water rail for a zetec then it will fit. the 1.1/1.3 HCS has a different hose arrangement and to the best of my memory doesnt have a water rail like a zetec (thermostat housing is the other end of the head. and the CVH is different yet again. What makes this post somewhat confusing is you havent specified what engine you have. but the water rails fusion do are for Zetec E engines.


alternatively. put up a picture of what your on about.



Jam.

heres a pic of the original water rail next the fusions rail. This is on a 2.0 zetec, same as the 1.6 and 1.8. Dont think it will fit though mate as MK3 1.3's were CVH engines and dont have the rail. Does it look anything like this ?

Iam abit confused, Lee's reply implies you told him you have a 1.3, but your also saying you have an Si (Si are 1.4 and 1.6 only), what Fiesta do you actually have ? a MK3 or MK4 and what engine ?

_________________

what engine do you have?
if it's a 1.6 just tell lee you're after a 1.6 fiesta zetec water rail.

_________________
My ebay stuff


Is that the best you can do?
-
2000 V70 T5 SE - 2.3, 5 cylinder, 20V, VVT, Turbo, 250bhp, cream leather, climate control, the works!