Hi, i brought a gas flowed inlet for my motor and fitted it today went fine only problem i got was one the the vaccum hoses (i think) broke as it was very had to get off. . . it is the biggest one that leads onto the back of the brake servo, the little plastic ring that held it in place on the inlet snap off as i used a flat head to get it off, iv just got the hose pushed in the hole at the moment with out one it dosnt seem that loose, does anyone know if that i went to FORD and got a new hose would it come that small plastic ring on it to plug in the inlet?? thanks

_________________
Siiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!!!!!!!!!!!!!!!!!!

im not sure but i doubt they would sell it with the pipe as that would be common sense, but i can check

on my rst engine mines the same but a bits still left in to keep it secured

i guess you didnt push the ring and the pipe in further to release it

_________________


fibre is my friend, more to come ;-) SI/T squirrel muncher

_________________
Siiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!!!!!!!!!!!!!!!!!!