Thought I'd better update this thread as I've been collecting bits for a while
The most import thing is I had the chance to buy another shell that was complete and in far better condition than my red one! The red one luckily wasnt scrapped, a few friends have taken it on as a track car project :drive: :cool!:
here is the new fez, sadly the week before i was due to collect it some stupid bint drove into the corner of the front wing :wall: ! Luckily most of it has been knocked out, I'll get it repaired properly at a later date -
it came with S2 seats, an xr2 anti roll bar and coil overs ( the rear springs had been chopped though
)
by , on Flickr
by , on Flickr
by , on Flickr
If I plan on driving it as a 1.1 I'll need a replacement rad
by , on Flickr
worst bit on the car is the stevie wonder handy work on the battery tray
, this will be sorted once the battery is moved to the boot :cool!:
by , on Flickr
by , on Flickr
I checked the car when I put a deposit down but I ripped the carpet up again and removed all the underlay matting stuff
by , on Flickr
All mint under the carpet :cool!:
by , on Flickr
my next job was to stripping all the sound deadening crap off the floor
by , on Flickr
slowly getting there
by , on Flickr
after alot of mincing its nearly done
by , on Flickr
I've also replaced the chopped springs with the springs that came with my other set of coil overs
by , on Flickr
now onto the parts I've collected ( i dont have pics for most of them as im lazy
) -
IB5 rear starter box with a quaife diff
Gaz coil overs
clutch and flywheel
vibratechnic engine and gearbox mounts
blacktop water pump pulley bracket
new dip stick and di stick tube
gates cambelt kit
new floflex poly bushes
by , on Flickr
new pattern lower sump and arp rod bolts
by , on Flickr
new water pump
by , on Flickr
I've also upgraded to a set of GSXR-1000 throttle bodies instead of the 600's
by , on Flickr
started to strip them down ready for spacing
by , on Flickr
roughly wedged in place :cool!: I'm having spacers made up in the next few weeks so that will pull them straight, as they are on the piss at the moment
by , on Flickr
by , on Flickr
]I've also collected a magnex stainless exhaust as I can't track down a scorpion at the moment
by , on Flickr
next on my shopping list is -
new block breather as mine is a little sh!t and rusty
1lt swirl pot with a lift pump and a S2 pump
DTA S60 ecu
water hoses
xr2 or vts rad
that's about it for now :cool!:
Login
Register
Main Website
Search
