| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| Vacuum readings????? https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=6459 |
Page 1 of 1 |
| Author: | Emlyn11 [ Wed Apr 18, 2007 1:04 pm ] |
| Post subject: | Vacuum readings????? |
| Author: | mike2530 [ Wed Apr 18, 2007 6:25 pm ] |
| Post subject: | Vacuum readings |
Where are you putting the vacuum guage ? Why are you trying to find out readings ? |
|
| Author: | Emlyn11 [ Sat Apr 21, 2007 12:03 pm ] |
| Post subject: | |
| Author: | mike2530 [ Sun Apr 22, 2007 7:41 pm ] |
| Post subject: | Vacuum readings |
Why do you think you have a vacuum leak ? |
|
| Author: | Emlyn11 [ Sun Apr 22, 2007 8:03 pm ] |
| Post subject: | |
because i can hear it, the car won't idle unles i VERY VERY gradully come off the throttle and even then its really lumpy. and i have basically replaced everything else on the entire car lol |
|
| Author: | mike2530 [ Sun Apr 22, 2007 8:11 pm ] |
| Post subject: | Vacuum readings |
What have you replaced and why ? |
|
| Author: | Emlyn11 [ Sun Apr 22, 2007 8:22 pm ] |
| Post subject: | |
i was being slightly sarcastic but i have replaced a lot of sensors, (because they were reading wrong) hoses, (because they were cracked/split) do you know weather you do a vacuum test on idle or at 2000rpm??? |
|
| Author: | saqmaster [ Wed Apr 25, 2007 11:20 am ] |
| Post subject: | |
You can do it anywhere, depending on what you're trying to achieve. -0.4 bar at idle is too low.. it should be around -0.6 bar on a zetec.. (around 40 kilopascals).. -Stu |
|
| Author: | Emlyn11 [ Wed Apr 25, 2007 12:09 pm ] |
| Post subject: | |
cheers mate, do you think i could have a leak then?? cheers emlyn |
|
| Author: | saqmaster [ Wed Apr 25, 2007 12:11 pm ] |
| Post subject: | |
Possibly.. or cam timing out! |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|