†Ûi³ÿßrȬþ;
ob_start();
?>
†Ûi³ÿßrȬþ;
ob_start();
?>
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4767: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4769: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4770: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4771: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| custom braided hoses https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=24075 |
Page 1 of 1 |
| Author: | AWOL [ Tue May 22, 2012 9:10 pm ] |
| Post subject: | custom braided hoses |
hey guys, i am wanting to change the copper lines on my project to braided lines, so far i have done fine but because i have fitted a larger servo, 2 fittings are 13mm... does anyone know where i can get this ![]() in 13mm?? cheers |
|
| Author: | elPaulio [ Tue May 22, 2012 9:38 pm ] |
| Post subject: | Re: custom braided hoses |
Why dont you just get the connector and hose with connector like the first pic here http://www.jag-lovers.org/xj-s/book/SSBrakeHoses.html ? Seems a lot easier to source. Paul |
|
| Author: | AWOL [ Tue May 22, 2012 9:46 pm ] |
| Post subject: | Re: custom braided hoses |
i was thinking of doing something like that however only found m10 or AN threads, i need M13 1MM pitch fitting... or a m13 to m10 threaded bush that i can then wind in an M10 into the servo, but would rather not do that |
|
| Author: | DanFraser [ Wed May 23, 2012 6:34 am ] |
| Post subject: | Re: custom braided hoses |
There's always the possibility of using a banjo bolt. |
|
| Author: | AWOL [ Sat May 26, 2012 4:38 pm ] |
| Post subject: | Re: custom braided hoses |
can you get banjo's im 13mm?? |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|