†Ûi³ÿßrȬþ; ob_start(); ?> †Ûi³ÿßrȬþ; ob_start(); ?> [phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4767: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4769: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4770: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4771: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
Fiesta-Si.com :: View topic - Efi inlet vacuum take off for map sensor
Fiesta-Si.com
https://www.fiesta-si.com/forums/

Efi inlet vacuum take off for map sensor
https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=22603
Page 1 of 1

Author:  rich.zs [ Tue Jun 21, 2011 8:59 pm ]
Post subject:  Efi inlet vacuum take off for map sensor

As said above, I'm doing a zetec e turbo conversion on my zetec s and will be using the efi HO inlet manifold now I need a vacuum for the map sensor is there anywhere I can take one off for it or t-piece another vacuum pipe for the map sensor ? Just to save me drilling a hole and tapping a thread for a fitting etc,

Also where can I get the vacuum for a boost gauge ? Again to save me making a fitting ?

Thanks In advance. Rich

Author:  happypaul [ Tue Jun 28, 2011 10:06 pm ]
Post subject:  Re: Efi inlet vacuum take off for map sensor

Your best off drilling 2 new holes and fitting nipples off that.

Not the hardest of jobs and will be better.

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/