†Ûi³ÿßrȬþ;
ob_start();
?>
†Ûi³ÿßrȬþ;
ob_start();
?>
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4767: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4769: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4770: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4771: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
loom & ecu https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=22259 |
Page 1 of 1 |
Author: | leetek [ Fri May 06, 2011 1:05 pm ] |
Post subject: | loom & ecu |
i got a 2.0l going in to my fiesta van the all i have read so far that mondeo ecu's plug straight in. the ecu i have has 104 pins the loom i have has 60 pins i believe the loom is from a escort. this is starting to get quite annoying as it is almost ready to start up. has anyone had this problem or can shed some light on to what loom i need. thanks lee |
Author: | Percy [ Fri May 06, 2011 1:31 pm ] |
Post subject: | Re: loom & ecu |
Welcome! For the ECU you to go staight in it needs to be a zetec loom, so basically the 1.6si, if its not the 1.6 zetec in there currently you will need to replace the loom with one from an Si. |
Author: | leetek [ Fri May 06, 2011 4:17 pm ] |
Post subject: | Re: loom & ecu |
Ok will i need the whole loom or just the engine loom |
Author: | onslack [ Mon May 09, 2011 9:26 am ] |
Post subject: | Re: loom & ecu |
you'll only need the engine loom from a 1.6 16v Si and the correct ecu (DEEP,DESK,DEWY), if you keep the multi plug that joins the engine loom to the main loom it should plug straight in, if wont plug straight in you can wire it in via that multi plug so the engine loom is still removable ![]() |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |