ok so ECU is currently lose in the passenger footwell but I cant get it to disconnected from the loom help please.
as simple as possible please
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| dammit ecu dropped into car can't disconnect it. https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=21925 |
Page 1 of 1 |
| Author: | Tiababy [ Fri Mar 18, 2011 9:01 pm ] |
| Post subject: | dammit ecu dropped into car can't disconnect it. |
ok so ECU is currently lose in the passenger footwell but I cant get it to disconnected from the loom help please. as simple as possible please
|
|
| Author: | big g1985 [ Fri Mar 18, 2011 9:45 pm ] |
| Post subject: | Re: dammit ecu dropped into car can't disconnect it. |
loosen the cage the ecu normally sits in push the ecu back into the cage and tighten it back up then go into the engine bay top passanger side undo the two bolts holding the loom cover inplace. once disconnected pull the cover out of the way and unscrew the centre bolt in the loom plug and once loose pull the plug off |
|
| Author: | Tiababy [ Fri Mar 18, 2011 9:51 pm ] |
| Post subject: | Re: dammit ecu dropped into car can't disconnect it. |
it was dropped through but as it was the original guru one it was being stubborn. got it now and the deep one is in place. now time to test.... |
|
| Author: | Tiababy [ Fri Mar 18, 2011 10:50 pm ] |
| Post subject: | Re: dammit ecu dropped into car can't disconnect it. |
yes we are sorted  idle is 100x better. the ECU is still learning as it's never been in a car but the power is lovely. |
|
| Author: | - Danny Boy - [ Fri Mar 18, 2011 11:02 pm ] |
| Post subject: | Re: dammit ecu dropped into car can't disconnect it. |
 Glad its sorted after all the agro!
|
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|