[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
Fiesta-Si.com :: View topic - mk5 fiesta 2.0 help backfiring issue
Fiesta-Si.com
https://www.fiesta-si.com/forums/

mk5 fiesta 2.0 help backfiring issue
https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=21147
Page 1 of 1

Author:  mitch [ Sun Dec 12, 2010 2:12 pm ]
Post subject:  mk5 fiesta 2.0 help backfiring issue

hi all just some advice needed i have just dropted a 2.0 silvertop in to a mk5 fiesta wired in the engine loom tryed cranking it and it does not run but backfires like a bomb has just gone off with 10 foot flames. i have checked the valve timing and its perfect has any one got any advice plz thanks

Author:  Tonwah [ Mon Dec 13, 2010 6:58 pm ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

Which managment are you using? Leads on the correct way? Correct cps sensor and cps mount used with the flywheel and box?

Author:  mitch [ Tue Dec 14, 2010 10:05 am ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

the ecu i am using is a desk mndeo ecu not to sure about the leads on the correct way, the crank sensor is the one that came from the mondeo silver top engine and i am not sure what flywheel is being used and it has a escort van 1.8 gearbox

Author:  Tonwah [ Tue Dec 14, 2010 7:16 pm ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

if your using the escort box then you will be using an escort/fiesta flywheel, when you change the flywheel, you need to change the cps and its holder to suit the flywheel, check in the mk3 1.6 to 2.0 conversion, then the cps sensor, will explain it better than i can

Author:  Fezzyzetec [ Wed Dec 15, 2010 7:25 pm ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

sounds like the fuel is not igniting properly thats why your getting flames out the back could be the crankshaft sensor m8 breaking down, what flywheel is on the car? and have you put the leads in the right order number 1 from the cambelt end not the coil pack end as that will cause firing issues

Author:  onslack [ Wed Dec 15, 2010 9:45 pm ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

100% sure its timed up correctly?

Author:  seanny 94 si [ Thu Dec 16, 2010 10:58 pm ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

It could be the cps sensor as it's designed for the 2 litre not for the 1.6 1.8 flywheel. Basically it's not picking up the signal properly and can be cause it to spark too late and that's probes why she's backfiring and not starting. Check and make sure.

Author:  Fezzyzetec [ Sun Dec 19, 2010 9:18 pm ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

all zetec cps are the same all they do is give a signal so wouldnt make a difference it running to rich or like i said above

Author:  leighk2010 [ Thu Dec 30, 2010 2:11 pm ]
Post subject:  Re: mk5 fiesta 2.0 help backfiring issue

any pics of the conversion mate i'm doing the same but with a 2.0 blacktop. What rad and pipe work have you gone for ?

and as for your problem is timing all correct have you got the leads from the coilpack on the right plugs etc so firing in the right order
any air leaks?

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/