Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
Undersealing my si https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=20607 |
Page 1 of 1 |
Author: | The Loumiester [ Mon Sep 20, 2010 3:39 pm ] |
Post subject: | Undersealing my si |
i want to underseal my si before the snow hits in about a month according to the papers. Now it hasnt been undesealed since iv had it so underneath could do with bit of tlc so what should i do? Should i sand it all down then put underseal on? What underseal should i use? How do i apply it? Basically everthing i need to know. Cheers Louis |
Author: | meilack [ Mon Sep 20, 2010 3:42 pm ] |
Post subject: | Re: Undersealing my si |
hammerite ![]() |
Author: | The Loumiester [ Mon Sep 20, 2010 4:37 pm ] |
Post subject: | Re: Undersealing my si |
From halfords? |
Author: | meilack [ Mon Sep 20, 2010 4:42 pm ] |
Post subject: | Re: Undersealing my si |
anywhere ![]() i think you should wire brush the rust at least and then paint it, obviously any welding is different lol |
Author: | Percy [ Mon Sep 20, 2010 4:57 pm ] |
Post subject: | Re: Undersealing my si |
As many thick coats as you can get on there. |
Author: | The Loumiester [ Mon Sep 20, 2010 6:15 pm ] |
Post subject: | Re: Undersealing my si |
okey dokey, may give it a shot this weekend. do you just brush it on? any idea how much it is? |
Author: | rob_fiesta [ Mon Sep 20, 2010 9:08 pm ] |
Post subject: | Re: Undersealing my si |
you can get underseal in to forms brush or spray |
Author: | Chris [ Mon Sep 20, 2010 9:14 pm ] |
Post subject: | Re: Undersealing my si |
I'd reccomend putting it on axle stands and spraying.... ![]() ![]() ![]() ![]() |
Author: | TANGO [ Mon Sep 20, 2010 9:19 pm ] |
Post subject: | Re: Undersealing my si |
suggested it in another thread last week, http://www.halfords.com/webapp/wcs/stor ... yId_165594 this stuff can be in spray and brush on and dries with a rubber feel so stones will bounce off it and not chip it away like normal hammerite would.. |
Author: | rob_fiesta [ Mon Sep 20, 2010 9:21 pm ] |
Post subject: | Re: Undersealing my si |
thats like the stuf i used for got name will take a pic off the can |
Author: | TANGO [ Mon Sep 20, 2010 9:26 pm ] |
Post subject: | Re: Undersealing my si |
its pretty much like the factory stuff thats already on and it looks spot on!! |
Author: | The Loumiester [ Mon Sep 20, 2010 10:09 pm ] |
Post subject: | Re: Undersealing my si |
sorted, im just hoping i can scrub it down good enough before i put it on. |
Author: | bensouthport [ Tue Oct 05, 2010 6:14 pm ] |
Post subject: | Re: Undersealing my si |
yeah i used hammerite with added waxoyl when i first did it. out of interest, how often do you need to underseal? if i had it done last year? |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |