| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| sill info https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=20058 |
Page 1 of 1 |
| Author: | rob_fiesta [ Thu Jul 01, 2010 10:29 pm ] |
| Post subject: | sill info |
hi all does any one know how hard it ir to put a new cill on my 5door and can i just use a mig welder thanks rob |
|
| Author: | seanny 94 si [ Thu Jul 01, 2010 11:50 pm ] |
| Post subject: | Re: sill info |
it depends how bad (rusty) the part is behind it to weld it to. dont think is to bad pretty sure its straight forward. just cut out old part and weld on new one, |
|
| Author: | InSane [ Fri Jul 02, 2010 5:20 am ] |
| Post subject: | Re: sill info |
your some times better to get a full sill.. when i put a sill on i put the sill over it then i mark the old sill by scratching with a nail then i know were to cut the old sill off also as the sill was spot welded on i get a spot weld remove bit ... when i put the new sill on i make shure it fits and then i take the old paint of also i drill the new sill with 6mm holes long the bottom edge about 25mm space between each and also on the top edge then when the sill is ready to weld i nomal weld though the holes and makes it look like a spot weld ..then mig the rest up P.S only drill the new sill |
|
| Author: | rob_fiesta [ Fri Jul 02, 2010 1:41 pm ] |
| Post subject: | Re: sill info |
i am getting a cover thing there is a big hole by the drivers door and by the back so i have to drill it the plug thing it with the mig yh ? cheers rob |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|