hi all my exhaust mid center is hanging low
so i undone the rubber hanger thing and tryed to get it to sit right but it will noe when ever i put the rubber hanger back on right it goes back to step one ! 
any idears plz help rob
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| exhaust help https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=19621 |
Page 1 of 1 |
| Author: | rob_fiesta [ Thu May 13, 2010 8:03 pm ] |
| Post subject: | exhaust help |
hi all my exhaust mid center is hanging low so i undone the rubber hanger thing and tryed to get it to sit right but it will noe when ever i put the rubber hanger back on right it goes back to step one ! any idears plz help rob
|
|
| Author: | TANGO [ Thu May 13, 2010 9:22 pm ] |
| Post subject: | Re: exhaust help |
try and get a couple of metal tie wraps and put that around the rubber, should help to take the stretch out of it!! |
|
| Author: | rob_fiesta [ Thu May 13, 2010 9:26 pm ] |
| Post subject: | Re: exhaust help |
will have a go to moz cheers |
|
| Author: | Zetecjon [ Fri May 14, 2010 5:11 pm ] |
| Post subject: | Re: exhaust help |
I've got powerflex exhuasts mounts could getting these for yours help being that ther alot stiffer ?? |
|
| Author: | stainlessmole [ Fri May 14, 2010 5:21 pm ] |
| Post subject: | Re: exhaust help |
Lol my mid section hung low for a while and then it ended up falling off at the cat. Try seeing if it is loose there. - pikey exhaust installers never tightened up the clip when they put on the new mid-section. So it was just hanging on, then all it took was to drive through a deep puddle and it was like VROOOM!! i was like wtf lmao |
|
| Author: | rob_fiesta [ Fri May 14, 2010 6:10 pm ] |
| Post subject: | Re: exhaust help |
cheers all i un done it all then clips and used the jack to get it high and then but the clips back on now it looks better not dragging on the floor cheers a de cat wont go oass mot will it ? rob |
|
| Author: | Zetecjon [ Sat May 15, 2010 9:26 am ] |
| Post subject: | Re: exhaust help |
Probably not mate but it can normally involve a drink to the mot bloke |
|
| Author: | Elward [ Sat May 15, 2010 12:00 pm ] |
| Post subject: | Re: exhaust help |
mine done this just loosen up the clips twist the midsection towards the car then tighten it all back up 
|
|
| Author: | rob_fiesta [ Sat May 15, 2010 10:15 pm ] |
| Post subject: | Re: exhaust help |
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|