hi there. iv recently got a 1.4 1994 si
however i do have an issue with it. when pulling up to lights or junction it can cutout. been told that if i disconnect the air flow meter this issue will stop?any help would be most welcome
Cheers John.
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| cutting out issues https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=18701 |
Page 1 of 1 |
| Author: | brailer [ Sun Jan 24, 2010 10:21 pm ] |
| Post subject: | cutting out issues |
hi there. iv recently got a 1.4 1994 si however i do have an issue with it. when pulling up to lights or junction it can cutout. been told that if i disconnect the air flow meter this issue will stop?any help would be most welcome Cheers John. |
|
| Author: | J9AYJ [ Sun Jan 24, 2010 10:33 pm ] |
| Post subject: | Re: cutting out issues |
doesnt sound like a maf fault tbh does it rev clean? |
|
| Author: | brailer [ Sun Jan 24, 2010 10:35 pm ] |
| Post subject: | Re: cutting out issues |
not sure aint really taken it far coz it cuts out 
|
|
| Author: | onslack [ Mon Jan 25, 2010 11:05 am ] |
| Post subject: | Re: cutting out issues |
not really had dealing with the 1.4 Si but it sounds like its the ISCV too me take it off and give it a clean with brake/carb cleaner |
|
| Author: | Percy [ Mon Jan 25, 2010 11:11 am ] |
| Post subject: | Re: cutting out issues |
| Author: | andyleesy [ Mon Jan 25, 2010 1:43 pm ] |
| Post subject: | Re: cutting out issues |
Don't the CVH engines have problems with blocked breather hoses? might be worth a check. Sounds awfully like ISCV though if it's the same mechanism as Zetec ones... |
|
| Author: | rob_fiesta [ Wed Jan 27, 2010 3:32 pm ] |
| Post subject: | Re: cutting out issues |
i had this in my 1.3 when i stared it and left i tit would cut out and i change the plugs and lead and fine now |
|
| Author: | DANIELP1991 [ Fri Jan 29, 2010 12:09 am ] |
| Post subject: | Re: cutting out issues |
alright mate! noticed your from south wales? where abouts are you? ive had to 1.4 sis now. clean idle speed control valve up like onslack said and also clean up the round black box thing next to the top left of the rocker cover! its a breather valve thing or sumin but they get clogged up with gunk. also give it a good service and it will run much better! 
|
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|