†Ûi³ÿßrȬþ; ob_start(); ?> †Ûi³ÿßrȬþ; ob_start(); ?> [phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4767: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4769: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4770: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4771: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
Fiesta-Si.com :: View topic - Rear wheel bearings. Hard to do?
Fiesta-Si.com
https://www.fiesta-si.com/forums/

Rear wheel bearings. Hard to do?
https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=18497
Page 1 of 1

Author:  russellv [ Mon Jan 04, 2010 9:05 pm ]
Post subject:  Rear wheel bearings. Hard to do?

Hi,

I have a 2 litre FSI and the rear wheel bearings have been gradually getting worse and worse!

Bought a couple of bearings from the local motorfactors and had a look through the Haynes and it looks hard?

Is it as hard as it looks without special tools (a press or anything)? Or should I just get a couple of half decent hubs from a scrappy and bolting the whole lot on?

Author:  Jam [ Thu Jan 07, 2010 12:34 am ]
Post subject:  Re: Rear wheel bearings. Hard to do?

you dont need a press for the back ones. hammer and a slightly bent cheapie screwdriver have served me well in changing taper roller bearings. and a big socket or block of wood for the seal. if your mechanicaly minded...its brain out of gear work...even if not. its not a difficult task... the only twattish bit will be getting the drums off if they are lipped.

personally i wouldnt bother going to the breakers...it might not make noises now..but no guarantee it wont in 6 weeks time..then its back to square one.

hope that helps.
Jam.

Author:  russellv [ Fri Jan 08, 2010 8:14 pm ]
Post subject:  Re: Rear wheel bearings. Hard to do?

Cheers Jam,

I will have a crack at it and let you know how I get on.

Loads of people must have had problems with them yet there are no guides on here? :doh:

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/