im not sure but i doubt they would sell it with the pipe as that would be common sense, but i can check
on my rst engine mines the same but a bits still left in to keep it secured
i guess you didnt push the ring and the pipe in further to release it
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| vaccum hose broke when fitting inlet manifold :s https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=15857 |
Page 1 of 1 |
| Author: | star2k8 [ Wed May 20, 2009 3:33 am ] |
| Post subject: | vaccum hose broke when fitting inlet manifold :s |
Hi, i brought a gas flowed inlet for my motor and fitted it today went fine only problem i got was one the the vaccum hoses (i think) broke as it was very had to get off. . . it is the biggest one that leads onto the back of the brake servo, the little plastic ring that held it in place on the inlet snap off as i used a flat head to get it off, iv just got the hose pushed in the hole at the moment with out one it dosnt seem that loose, does anyone know if that i went to FORD and got a new hose would it come that small plastic ring on it to plug in the inlet?? thanks |
|
| Author: | Mouse [ Wed May 20, 2009 10:44 pm ] |
| Post subject: | Re: vaccum hose broke when fitting inlet manifold :s |
im not sure but i doubt they would sell it with the pipe as that would be common sense, but i can check on my rst engine mines the same but a bits still left in to keep it secured i guess you didnt push the ring and the pipe in further to release it
|
|
| Author: | star2k8 [ Wed May 20, 2009 11:09 pm ] |
| Post subject: | Re: vaccum hose broke when fitting inlet manifold :s |
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|