| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| help putting a non pas engine into a pas car https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=13508 |
Page 1 of 1 |
| Author: | big g1985 [ Mon Nov 17, 2008 1:59 pm ] |
| Post subject: | help putting a non pas engine into a pas car |
ive just bought a n plate mk3.5 fiesta si to replace my very rottern rs1800 project basically im goning to swap the good stuff over to the si. im going to use the rs1800 engine because ive put a new timing belt, water pump and clutch on it so is it easier to swap the pas stuff off the si engine or swap the pas steering rack for the non pas steering rack from the rs? cheers |
|
| Author: | onslack [ Mon Nov 17, 2008 2:05 pm ] |
| Post subject: | Re: help putting a non pas engine into a pas car |
imo if you want an easy job use the pas stuff off the 1.6 engine, leaving the pas rack etc on the Si, so its a case of dropping the engine in or.. replace/swap the non pas stuff over from the RS, which takes longer and could turn out to be a pain! i'd go for the dead easy option myself as i'm a lazy so and so 
|
|
| Author: | meilack [ Mon Nov 17, 2008 2:06 pm ] |
| Post subject: | Re: help putting a non pas engine into a pas car |
you can say that again  But tbh, i agree with him 
|
|
| Author: | fonfe [ Mon Nov 17, 2008 6:37 pm ] |
| Post subject: | Re: help putting a non pas engine into a pas car |
definatly put just put the pas pump onto the rs lump, all the holes are still on the block so will be no problem to do. do it once the engine is bolted up to the mount in the bay though or its a pain to try to get the engine in. |
|
| Author: | happypaul [ Tue Nov 18, 2008 11:39 am ] |
| Post subject: | Re: help putting a non pas engine into a pas car |
I'd put the manual rack on the Si and get rid of PAS  No need for it in a Fiesta IMO |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|