†Ûi³ÿßrȬþ;
ob_start();
?>
†Ûi³ÿßrȬþ;
ob_start();
?>
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/session.php on line 1056: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions_content.php on line 696: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4767: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4769: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4770: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4771: Cannot modify header information - headers already sent by (output started at [ROOT]/config.php:19)
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| inlet https://www.fiesta-si.com/forums/viewtopic.php?f=4&t=11353 |
Page 1 of 1 |
| Author: | rs1800rob [ Sun May 04, 2008 7:34 pm ] |
| Post subject: | inlet |
hi all i changed my inlet from my rs1800 to my 1.8 xr2i now my car feels sluggish,shall i change my ecu to the to he rs1800 one aswell? |
|
| Author: | Bow [ Sun May 04, 2008 8:10 pm ] |
| Post subject: | Re: inlet |
It wouldn't make much difference(if any) to be honest m8. Sounds like theres a few things you might need sorting first! |
|
| Author: | happypaul [ Sun May 04, 2008 8:39 pm ] |
| Post subject: | Re: inlet |
By fitting the HO inlet you lose lower down Torque. But gain top end power/torque. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|