how do u remove this people what does it do,not too clued up about this sort of thing only electrics lol

unscrew the pipes conected to your exhaust manifold, they dont come out easy but a bit of wd40 will help

the box is on a bracket near the starter motor, the bracket can also be removed

to plug up the holes left in your manifold they are M16 x 1.5 (metreic fine) you can get them in a local hard ware store but will need to cut them down to about 10mm of thread and use some gasket sealant on the threads

good luck dude any questions pm me

_________________

well egr stands for exhaust gas recirculation, although now on modern day vehicles with direct injection you will find they dont really use EGR, but modern diesels use it very efficiently (obviously depending upon manafacturer).
The purpose of it is to take a percentage of burnt fuel (exhaust gases) and pump them back through into the inlet manifold to be burnt again, this reduces poisonous gases flowing out through your exhaust, and in effect reduces damage to the atmosphere ozone layer and all that jazz.

Once you have removed the EGR pipes and unit, You can buy the studs as "blanking plugs" for about a fiver from ford i think, although obviously make sure you give them details that it is a ford mondeo with a 2L engine so they can look the number up for you.

edit-as i dont think they are listed for a 1.6L zetec, could be wrong

here is a small picture i posted a few months ago (a bit crap):

_________________

_________________
My ebay stuff


Is that the best you can do?
-
2000 V70 T5 SE - 2.3, 5 cylinder, 20V, VVT, Turbo, 250bhp, cream leather, climate control, the works!