I'm finally getting there on my car.
I have Focus 15's on with some slightly too big tyres and a whopper of an offset of 52.5 (!). I've put them on the rear and they look like they have 5mm+ clearance on everything, that should be enough shouldn't it? Or should I space them out a little bit because the front wheels are getting spaced out?
What's the best way to remove a broken bleeding nipple off a caliper? This one is sunken in, had a go at drilling (using a slightly smaller drill bit than the thread size on the new one) but it's hard as hell and the drill snagged a chunk of it and shoved it in the hole even more
Would you trust a driveshaft and hub from a car in a scrappy? Turns out the current (old) one was ruined in the pothole damage too, being split and me easily able to pull off the outer parts and the main shaft itself, then levering off the rest and 3 or 4 parts dropping into the bucket.
Login
Register
Main Website
Search
