Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
can u take the hole maf sencer housing off to fit conefilter https://www.fiesta-si.com/forums/viewtopic.php?f=13&t=555 |
Page 1 of 1 |
Author: | danny boy [ Sun Apr 17, 2005 11:51 am ] |
Post subject: | can u take the hole maf sencer housing off to fit conefilter |
hi people just wondering if u can take the hole maf sencer housing off and fit a universal cone filter to the small rubber pipe in front of it.will the engine run properly dont want it to run lean. |
Author: | Traser [ Sun Apr 17, 2005 4:45 pm ] |
Post subject: | |
Author: | scotty_boy BSc [ Sun Apr 17, 2005 6:56 pm ] |
Post subject: | |
Author: | Traser [ Sun Apr 17, 2005 11:20 pm ] |
Post subject: | |
Author: | jdfiesta [ Mon Apr 18, 2005 12:07 pm ] |
Post subject: | |
yes you can take it off if need be, but the ecu will run with one sensor less. but, why dont you just buy a proper K&N or the car? JJ |
Author: | TonyBlackFRST [ Mon Apr 18, 2005 1:34 pm ] |
Post subject: | |
yes you can take it off but i wouldn't advise it the MAF (mass air flow) sensor is there for a reason. it measures the airfloe and your ecu will adjust the fueling accordingly so basically without running the MAF your fueling will be shot it will either run rich. not the end of the world but you'll be looking at stupid fuel consumption, having the constant smell of petrol in your car and when you start it up it'll prob flood cos as the choke is on it will be pouring way to much fuel into your engine or it'll run lean, in which case you'll suffer from detonation and if you dont catch it in time you'll eat headgasket at best and be in for total engine rebuild at worse. which even if you then go 2.0 works out at around ?500-?1000 for putting on an airfilter. your call mate but your engine will get damaged if you dont run it Tony ![]() |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |