I've been paid, so i want to buy poly wishbone bushes.
But they come in 3 different sizes, 46mm, 47mm, 54mm
How do i know what size i need?
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| Wishbones https://www.fiesta-si.com/forums/viewtopic.php?f=13&t=21531 |
Page 1 of 1 |
| Author: | stainlessmole [ Mon Jan 31, 2011 12:48 pm ] |
| Post subject: | Wishbones |
I've been paid, so i want to buy poly wishbone bushes. But they come in 3 different sizes, 46mm, 47mm, 54mm How do i know what size i need?
|
|
| Author: | stuff n that [ Mon Jan 31, 2011 2:15 pm ] |
| Post subject: | Re: Wishbones |
i measured mine from a 1994 16v and they were 46mm. im not sure if the size differs from the year/spec of car or the make of wishbone though
|
|
| Author: | stainlessmole [ Mon Jan 31, 2011 2:19 pm ] |
| Post subject: | Re: Wishbones |
Yeah that was what i was thinking. How did you measure it, did you take out the bush? |
|
| Author: | stuff n that [ Mon Jan 31, 2011 2:34 pm ] |
| Post subject: | Re: Wishbones |
yeah i pressed the bushes out and measured them with verniers, had 2 spare sets so measured them both and they were both 46mm front bush and 54mm rear bush but i think the rear bush is a standard size 
|
|
| Author: | stainlessmole [ Mon Jan 31, 2011 2:36 pm ] |
| Post subject: | Re: Wishbones |
Thanks mate, are the bushes easy to take in and out lol? Because if the rubber ones are difficult then i'm gunna have a job to fit the poly bushes haha |
|
| Author: | stuff n that [ Mon Jan 31, 2011 2:48 pm ] |
| Post subject: | Re: Wishbones |
i used a press to get mine out, if u dont have access to 1 then i would use a drill to get the rubber out and chisel away at the thin metal that surrounds the bush and it will eventually come out. the polys are easy enough to get in if u clean the wishbone up and use the supplied grease
|
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|