| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| Pic request. Mk3 with throttle bodys https://www.fiesta-si.com/forums/viewtopic.php?f=13&t=20781 |
Page 1 of 1 |
| Author: | james_rs [ Fri Oct 15, 2010 10:48 am ] |
| Post subject: | Pic request. Mk3 with throttle bodys |
Any one got any pics of a mk3 with throttle bodys? Ideally need to see what sort of clearance there is. Planning a set up with st170 lower inlet and gsxr bodies, not to sure how much room there is to play with when its all build up. |
|
| Author: | big g1985 [ Fri Oct 15, 2010 1:57 pm ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
|
|
|
| Author: | will121 [ Fri Oct 15, 2010 6:00 pm ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
not a lot of room especially if you want to run a filter, i dont know what the angle of the ST inlet is but most clearance is gained by being angled up to miss the bulkhead, GSXR throttle bodies bit longer than purpose made car ones but have got both GSXR600 and larger 750's to fit ok with short trumpets 750 set up on the bench  600's  current 750's with filter  
|
|
| Author: | onslack [ Mon Oct 18, 2010 8:29 am ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
sorry to hi-jack cookie  Will, what are the difference's from having the 600's to 750's to 1000's fitted? i know they are larger/smaller etc, but do the smaller ones have better low down torque?
|
|
| Author: | will121 [ Mon Oct 18, 2010 12:26 pm ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
| Author: | james_rs [ Mon Oct 18, 2010 8:47 pm ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
| Author: | will121 [ Mon Oct 18, 2010 9:19 pm ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
this is what GSXR throttle bodies on a ST manifold setup looks like dont know what angle is though as from another web site 
|
|
| Author: | onslack [ Tue Oct 19, 2010 8:36 am ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
| Author: | will121 [ Tue Oct 19, 2010 10:31 am ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
| Author: | onslack [ Tue Oct 19, 2010 10:33 am ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
awesome stuff  keep us posted on how that goes, i was going to use the st170 injectors and blank the gsxr injector ports/holes 
|
|
| Author: | seanny 94 si [ Tue Oct 19, 2010 7:38 pm ] |
| Post subject: | Re: Pic request. Mk3 with throttle bodys |
that should be pretty good fun. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|