Do you have to change over the master cylinders or anything so the pipe work lines up or anything?
or any other mods you have to do?
cheers
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| Fitting a mk6 escort servo/master cylinder https://www.fiesta-si.com/forums/viewtopic.php?f=13&t=19328 |
Page 1 of 1 |
| Author: | will87 [ Tue Apr 06, 2010 1:31 am ] |
| Post subject: | Fitting a mk6 escort servo/master cylinder |
Do you have to change over the master cylinders or anything so the pipe work lines up or anything? or any other mods you have to do? cheers
|
|
| Author: | Jam [ Tue Apr 06, 2010 10:33 am ] |
| Post subject: | Re: Fitting a mk6 escort servo/master cylinder |
arm at the back needs shortening by 19mm iirc. mk6 cylinder wont fit a mk3 servo. you have to swap the lot. youll have to adjust the holes in the bracket with a drill to 10 or 11mm. and the brake pipes when i did mine way back when i just gingerly teased them into shape  HTH Jam. |
|
| Author: | will87 [ Wed Apr 07, 2010 12:32 am ] |
| Post subject: | Re: Fitting a mk6 escort servo/master cylinder |
ok thanks for that mate how do i go about shortening the arm? |
|
| Author: | Jam [ Thu Apr 08, 2010 9:52 am ] |
| Post subject: | Re: Fitting a mk6 escort servo/master cylinder |
cut the fork off directly behind it where it joins onto the rod. cut 18mm off..file the other 1mm down so its nice and level. the tricky bit is welding it back on. namely because you need to keep the heat soak to a minimum. we used 2 pairs of mole grips and alot of damp cloth to soak the heat out of the rod..only for if it travels to far in it will bugger the servo. to be honest. the mondeo cylinder looks an easier conversion as apposed to this as there is no cutting or buggering about. Jam. |
|
| Author: | will87 [ Thu Apr 08, 2010 11:39 am ] |
| Post subject: | Re: Fitting a mk6 escort servo/master cylinder |
ok mate i think i might look for a mondeo one
|
|
| Author: | will121 [ Thu Apr 08, 2010 8:26 pm ] |
| Post subject: | Re: Fitting a mk6 escort servo/master cylinder |
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|