I have posted in this section as i have had no replys in the tec section so sorry if any inconvienence

Righty Im chucking a 1800 zetec in my 1.3, the list of parts i have are-

The engine with ancillerys( basically its complete) its a 1.8 EFI - early one out of a escort or something
ECU and loom
si fuel tank and sender
all inlet gear - mass air flow sensor n air box and pipes ect
ive put si front struts and brakes and hubs ect on the car
oil and filter
engine has a clutch
an engine mount from a fiesta si
I have an ignition module but i have been told my engine loom has it intergrated
And im being mad and bolting the engine to the 1300 box.
A zetec-s exhaust system, a zetec downpipe ect will have to be welded but not a problem
I am not having power steering so im having a aux belt made or finding one to fit - also not a problem
ect ect ect

A friend of mine has done the conversion about 100 times and told me all i need.

Basically have anyone got the know how on the wiring loom side? ie. wiring it to the 1.3 loom.
Any wiring diagrams or can someone make one up?

Im doing it starting from next friday as i dont need my car as im going on a 2 week course.

Any help would be greatly apprciated!

_________________
1991 Polo GT Coupe

To be honest mate, if it were me I would fit a full si loom to the car rather than bodging the
engine loom in, it would be soo much neater afterwards aswell.

I'm affraid I can't help with wiring it up to the 1.3 loom but maybe you should
think about changing the whole lot.

Emlyn

_________________