just desided that i cant be arsed with it and another si is on the list
| Fiesta-Si.com https://www.fiesta-si.com/forums/ |
|
| ready to drop the enigne out https://www.fiesta-si.com/forums/viewtopic.php?f=1&t=1961 |
Page 1 of 1 |
| Author: | luke89 [ Sun Dec 18, 2005 7:04 pm ] |
| Post subject: | ready to drop the enigne out |
| Author: | Mouse [ Sun Dec 18, 2005 7:25 pm ] |
| Post subject: | |
nothing to worry about the p.a.s just undo any connections near the bottem ov the car and the fluid ull drain out but not all so b prepared when u take the pipes of to c some oil come out it works by a pump thats connected to the alternator belt just dont start the car when uve got it disconnected coz it ull fook the pump up also if u disconnect the pipes on the steering rack thay ull b a small valve in one ov the holes dont loose it and remember witch hole it come out ov. it should b the top hole what gear box u using coz if its the 1.6 gearbox its best to chage the 1.8 fly wheel one for the 1.6 coz its slightly bigger i think it depends if uve got an engine lift but i find it quicker and easer getting the gearbox off then lifting the engine out the top but u can drop the whle lot out the bottem buy practicly disconnecting all the suspension hope this helps |
|
| Author: | luke89 [ Mon Dec 19, 2005 2:26 am ] |
| Post subject: | |
| Author: | Mouse [ Mon Dec 19, 2005 2:59 am ] |
| Post subject: | |
| Author: | scotty_boy BSc [ Mon Dec 19, 2005 2:35 pm ] |
| Post subject: | |
| Author: | luke89 [ Mon Dec 19, 2005 10:57 pm ] |
| Post subject: | |
just desided that i cant be arsed with it and another si is on the list
|
|
| Author: | jdfiesta [ Tue Dec 20, 2005 4:02 pm ] |
| Post subject: | |
| Author: | MallardSi [ Fri Dec 30, 2005 7:53 pm ] |
| Post subject: | |
| Author: | luke89 [ Sat Dec 31, 2005 4:13 pm ] |
| Post subject: | |
i have stoped my project for a little bit till the 6th of jan to finesh of my other project what is now MOT ready   and waitin on the full respray as there cople bits of surface rust , oh its also done more that 140k no knoks rattles or slipin cluch ( been replaced at some point also has been looked ater well ) look out for pics in the gallery and bring on the 6th on jan when the si will acculy get a look in 
|
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|