Fiesta-Si.com
http://www.fiesta-si.com/forums/

2.0 Turbo project...not your run of the mill project.
http://www.fiesta-si.com/forums/viewtopic.php?f=5&t=20180
Page 8 of 8

Author:  onslack [ Fri May 09, 2014 10:28 am ]
Post subject:  Re: 2.0 Turbo project...not your run of the mill project.

Looking good there paul, good to see you making some progress :thumbsup:

Author:  happypaul [ Tue Mar 24, 2015 9:21 pm ]
Post subject:  Re: 2.0 Turbo project...not your run of the mill project.

No updates as such.

But once I have completed my training contract nearer the back half of this year, pending a full time contract I shall be able to move the Si and all it's parts to a more suitable place.

This place being a RAF car club with ramp welders air tools etc etc.

I could take it now but I'm reluctant to do so, because of the slight chance of not getting a full time contract on this base.... which would mean moving it all again.

Eventually this project will get a swift kick up the arse and will get a lot of updates.

Author:  meilack [ Wed Mar 25, 2015 8:39 am ]
Post subject:  Re: 2.0 Turbo project...not your run of the mill project.

awesome :D

Author:  bensouthport [ Mon Mar 30, 2015 11:56 am ]
Post subject:  Re: 2.0 Turbo project...not your run of the mill project.

sounds brilliant Paul! Good luck

Author:  happypaul [ Sun May 08, 2016 8:50 pm ]
Post subject:  Re: 2.0 Turbo project...not your run of the mill project.

Update I guess.

Collected ST170 engine fairly recently and is sat in my back yard. Needing to find a company local to me who can bore it out to fit the pistons. And realistically I can build up the engine at my current address.

Full time position on the RAF base now although the car club changed rules on welding and then I struggled to renew my pass for this year and haven't bothered since. Going to pursue this again but I cant see me moving the shell 60 miles to work on it once a month.

Will have my own house and garage in about 2 years so unless I can get shared lockup.. The si will just be getting parts gathered for it lol

Author:  meilack [ Wed Oct 12, 2016 1:33 pm ]
Post subject:  Re: 2.0 Turbo project...not your run of the mill project.

any updates? :P

Page 8 of 8 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/